DTX Series CableAnalyzer
Technical Reference Handbook
2-14
Step 1: Installing the Fiber Modules
1-1
Turn off the tester and smart remote.
1-2
Remove the cover from the back of each unit and install
a DTX-MFM2, DTX-GFM2, or DTX-SFM2 module in each
unit, as shown in Figure 2-8.
amd34af.eps
Figure 2-8. Installing Fiber Modules
WCaution
Leave the module bay covers in place when the
fiber modules are not installed.
Step 2: Checking the Battery Status and Verifying
Operation with Fiber Modules
2-1
Clean and inspect the tester’s connectors and the
connectors on two SC/SC test reference cords. See page
8-9 for details on cleaning.
2-2
Connect the tester and smart remote together, as
shown in
Figure 2-9.
2-3
Turn the rotary switch to SPECIAL FUNCTIONS.
2-4
Use D to highlight Battery Status; then press
H. Press I when you are done.
2-5
Use D to highlight Self Test; then press H.
2-6
Press Pto start the self test.
To Next Page
Loading...
