DTX-MFM2/GFM2/SFM2 Fiber Modules
Users Manual
32
Autotest in Far End Source Mode
Use Far End Source mode to measure loss at one
wavelength on individual fibers.
Far End Source mode requires a stand-alone optical
source. Figure 13 shows the equipment required for
testing fiber in Far End Source mode.
amd51f.eps
A Tester and smart remote with fiber modules and
connector adapters installed (match connector adapters
to the connectors in the link)
B Memory card (optional)
C Two AC adapters with line cords (optional)
D Reference test cord. Match the fiber to be tested. SC
connector at one end. Match the link connectors at the
other end.
E Reference test cord. Match the fiber and connectors in
the link.
F Mandrel. Recommended when testing multimode fiber
with a DTX-MFM2 module. See page 12.
G Fiber cleaning supplies
Figure 13. Equipment for Testing in Far End Source Mode (Method B)
To Next Page
Loading...
