Fluke PLS RBP5 - Page 3

3
• Remove the RBP5 if PLS laser level is not used for an
extended period of time, or if stored in temperatures above
50 °C. If RBP5 battery pack is not removed, battery leakage
can damage PLS laser level.
• Replace the RBP5 battery pack when the low battery indicator
of PLS laser level shows to prevent incorrect measurements.
• RBP5 battery pack can be charged while operating the
PLS laser level, but we do not specify charge time.
• Use only Fluke approved power adapters to charge the battery.
• Do not short the battery terminals together.
• Do not disassemble or crush battery cells and battery packs.
• Do not keep cells or batteries in a container where the
terminals can be shorted.
• Do not put battery cells and battery packs near heat or re.
Do not put in sunlight.
• Do not use the RBP5 around explosive gas, vapor, or in
damp or wet environments.