Flycam HD-3000 - Introduction and Contents; Introduction; In the Box

2
 Aach Central Post to the Base Plaorm by
means of threaded stud in center. Rotate
the Base Plaorm to properly secure with
Central post.
 Loosen allen bolts at the boom of Camera
Plaorm, align its holes with top of Central
Post & re-ghten them with allen key
securing the plaorm to post.
HD-3000 Stabilizer Setup
 Open the lever and remove Quick Release
Plate from Adapter. Then aach it with your
camera with the help of screw driver. Insert
your camera setup into the Adapter and
ghten the lever back.
 Connuing the assembly and balance
requirements to make your Flycam
Handheld Video Stabilizer fully funconal
you will note that the base plaorm has a
provision to mount the balance weights via
2x BH bolts secured with knobs on both
sides of the post.
NOTE: The camera can be directly aached to Head Plate.
 Remove Head plate from 3-piece Head Assembly in order to aach it to your camera. You will note a
number of mounng holes that can be used to adapt various cameras. Keep the camera in center of
Head Plate and secure it properly.
 Do not over ghten this adjustment as it can break the threaded insert.
NOTE: You can also mount your camera using Quick Release Plate.
Adding Weights & Posioning for Proper Balance