1 3 . Make sure the opening of the chipping tube is always covered while not at
work in case children place their hands into the tube.
14 .
To
move the machine, firmly hold the handle with both hands, step on the
shaft on the rear wheel with one foot, lift the front of machine, pay attention to
center of gravity of machine, walk slowly forward, backward or turn around.
15. Before operating the machine, please check the direction of the wind to avoid
working downwind of exhaust .
16. Keep all guards and deflectors in place and in good working condition.
17. Muffler and engine become hot and can cause a burn. Do not touch.
18. Turn off machine before transport the machine.
19. Do not tilt the machine while the engine is running .
IV.
IV.
IV.
IV.
Maintenance
Maintenance
Maintenance
Maintenance and
and
and
and storage
storage
storage
storage
1. When the machine needs servicing, inspection, or storage, or to replace a part ,
turn off the engine, make sure all the moving parts are completely stop ped and
allow the machine to cool before making any inspections, adjustment etc.
2. Store the machine where fuel vapors will not reach an open flame or spark. If
the machine is stored for a long time, drain the fuel out of the machine. Make
sure the machine is cool before storing.
3. When the cutting blades need servicing, remove them manually when the
machine is stopped .
V.
V.
V.
V.
Additional
Additional
Additional
Additional safety
safety
safety
safety instructions
instructions
instructions
instructions for
for
for
for machine
machine
machine
machine with
with
with
with bagging
bagging
bagging
bagging attachment
attachment
attachment
attachment
Before attaching or removing the bag, the engine should be shut off. Cover the
To Next Page
Loading...