of discharge while machine is on operation.
10. Set back the cover to the side tube once finishing chipping.
VII.
VII.
VII.
VII. Leaves
Leaves
Leaves
Leaves and
and
and
and Grass
Grass
Grass
Grass Shredding
Shredding
Shredding
Shredding
1. Leaves and short stalk (bean plants), cobs, sod and similar material should be
fed into the hopper and chipped in 16 interlaced chipping lots.
2. Do not open the plastic cover when adding more material.
3. If t he leaves and similar material proves difficult to enter the hopper, use a
wooden stick to push them in , instead of by hand , or other metal bars.
4. Keep your face and body away from the feed hopper to avoid being struck by
any material that may bounce back.
5. The discharge area is easily clogged if the material is moist. Always stop the
engine before clearing build-up with wood tools. Never use your hand or foot.
6. Never attempt to clear an accumulation of processed material when engine is
still on operating .
7. For the processing of organic garden mulch complete the following:
Put the discharge towards a wall, large board or other obstruction. Open the
discharge door and remove the screen to allow the processed material pile up.
With a garden spade feed this material into the shredder until it reaches the
consistency you want.
Keep pet s and bystander s away from the discharge area while the machine is in
operation. Set the screen back to the place and close the discharge door when
shredding is finished.
To Next Page
Loading...