---Never add fuel to the machine indoors.
---Do not smoke while adding fuel.
---Never refuel or store the machine in a place where there is open flame, spark
or other ignition object.
---Do not attempt to start the power source if fuel is spilled . W ipe away the
spillage and put it far away from the area before starting the machine.
---Always make sure the fuel cap is securely tightened and replace before starting .
---If the fuel tank needs to be drained, it should be done outdoors.
7. The starter handle is located on the engine. Pull the starter handle to start the
engine. Check the machine is in proper working condition after starting engine.
8. Chipper chute — allow twigs and small branches up to 4 ” in diameter to be fed
into the impeller for chipping.
9. Chip p ing funnel — allow leaves and small branches up to 1/4 ” diameter to be
fed into the funnel for chipping and shredding.
10. Lawn tractor or
ATV
trailer hitch — to be used for towing
by
lawn tractors or
ATVs
at speeds below 20kmh.
iii. Operation
1. Make sure the plastic cover on upper hopper is closed when your shredder is
running. Flying chips are very hazardous.
2 . Use a rough wooden stick to push the material in to the feed hopper. Do not
use your hands or metal tools.
3. Keep your face and body away from the feed intake opening.
To Next Page
Loading...