Flying Scot Bow Air Bag

To Next Page

Bow Air Bag Instructions

Kit Includes

• Bow Air Bag

• Set Webbing Straps

• Flotation Tangs with Screws and Washers

• Wood Blocks with Fiberglass Patches

Additional Material Required

• Resin

• Gel Coat

• 3” disposable bristle paint brush

• Acetone

• Rags

• 80 Grit Sandpaper

• Hammer

• Cordless Drill w/ 1/8” bit

• Phillips Screwdriver

• Tape Measure

Before Beginning Please Thoroughly Read Through All Instructions.

Please call us at 1-800-864-7208 with any questions.

Wood Block Installation

1. In order to provide maximum lift, the bag should be secured to the floor of the boat just forward of the

centerboard trunk. Use the sketch to locate the position for the wood blocks.

2. Lay the uninflated air bag in the bow to be sure the position of the blocks is correct.

These instructions are intended for the exclusive use of Flying Scot, Inc. customers. Any unauthorized use is strictly prohibited.

Need help?

Do you have a question about the Flying Scot Bow Air Bag and is the answer not in the manual?

Flying Scot Bow Air Bag Specifications

General