Flymo Power Hoe - Page 7

6
USE
To start the Power Hoe
1. Form a loop in the mains cable
and push the loop through the
slot as illustrated in Fig J1.
2. To secure, position loop over the
hook (J2) and pull the cable
back through the slot (J3).
3. Connect plug to mains and
switch on.
4. For slower speeds
see note,
move rocker switch forward with
thumb and squeeze switch lever
on handle (See Fig. K). Keeping
the switch lever squeezed, the
thumb can be removed from the
rocker switch.
5. For faster speeds see note,
rocker switch backward with
thumb and squeeze switch lever
on handle (See Fig. L). Keeping
the switch lever squeezed, the
thumb can be removed from the
rocker switch.
6. When the Power Hoe has
reached required speed, gently
lower it into the soil.
•
Note
The speed can be varied by
slightly releasing pressure on
the switch lever. (Fig M)
To stop the Power Hoe
1. Fully release the pressure on the
switch lever. (Fig. N)
Starting & Stopping
J
1
2
1
2
K
L
M
N
1 2
3