EasyManua.ls Logo

Flytec V801 - Page 4

Flytec V801
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fixed-speed cruise
1. Push the joystick up
2. Long press the xed-speed cruise button to enter the xed-speed
cruise mode
3. The remote control joystick can ne-tune the direction of the boat
Remarks: After entering the xed-speed cruise control mode, press the
xed-speed cruise button again to exit the cruise control
Lighting control
1. Press the lighting button on the remote control, the headlights of the boat will
ash. Press again to keep the headlights on, and press again to turn o the
lights
2. When the boat turns left, the left tail light is always on; when the boat turns
right, the right tail light is always on
Low battery reminder
1. When the boat is in a low battery state, the remote controller will make a
"beep" and "beep" prompt sound
2. When the remote control is in a low battery state, the indicator light of the
remote control will ash
Start up
1. Place the boat on a at road and turn on the power of the boat
2. Push the switch of the remote control, the indicator light of the remote
control is always on, the front light of the boat is not on
Note: Do not place the boat on a slope before it is paired. Operate the left
and right motors to see if they work before putting in the water
Frequency Matching
Press the OK button on the remote control and hold, then turn on the boat
switch, nally turn on the remote control switch, and when you hear a "beep"
sound, the frequency pairing is complete
When the boat is not matching with the remote controlplease try this
method to repair it
V801 bait boat