FMG FMT-Lx - Page 14

FMT- QA Installation and Operation Instructions - Page 14 of 16
Declaration of Conformity
This “Declaration of Conformity“ complies with the European Standards
- NEN-EN-ISO/IEC 17050-1:2010, Conformity assessment - Supplier's declaration of conformity – Part 1
“General Requirements” and where applicable,
- NEN-EN-ISO/IEC 17050-2:2004, Conformity assessment - Supplier's declaration of conformity – Part 2
“Supporting documentation”.
We: Flow Meter Group B.V.
Meniststraat 5c, 7091 ZZ Dinxperlo, The Netherlands
declare under our sole responsibility that the product(s)
Product: Turbine Gas Meter
Type: FMT-L + FMT-S + FMT-Q
to which this declaration relates are in conformity with the relevant sections of the following standard(s)
EN12261 ASME B31.8 EN13445 ASME VIII Div. 1 EN 1127-1
EN 13463-1 EN 13463-5 EN 60079-0 EN 60079-11 EN 60079-26
and where applicable following the provisions of EU Directive(s)
Pressure Equipment Directive (97/23/EC)
Conformity assessment body involved for Annex III (Module B + D):
Lloyd’s Register Verification Limited
71 Fenchurch Street, London EC3M 4BS, United Kingdom, NB number: 0038
Marking:
 0038
Certificates: CE-PED-B-4.13.0950-00-13-NLD, 9004926
ATEX 95 (94/9/EC)
Conformity assessment body involved for Annex VIII (Module A+):
Lloyd’s Register Verification Limited
71 Fenchurch Street, London EC3M 4BS, United Kingdom, NB number: 0038
Marking:
 II 2 G T4
Signature:
Name: Paul Hoeks
Position: CEO Flow Meter Group B.V.
Dinxperlo, 1 October 2013