Need help?Do you have a question about the FMS 1:24 FCX24 UNIMOG and is the answer not in the manual?
General| Scale | 1:24 |
|---|---|
| Drive System | 4WD |
| Motor Type | Brushed |
| Remote Control | 2.4GHz |
| LED Lights | Yes |
| Tire Type | all-terrain |
| Charging Time | About 2 hours |
| Run Time | 20-30 minutes |
| Control Range | Up to 50 meters |
| Waterproof | Yes |
Introduction to the product and manual.
Declaration of conformity with RED 2014/53/EU.
RF exposure compliance and antenna installation guidelines.
FCC compliance statement for digital devices.
Guidelines for disposing of old electrical appliances.
Information about the radio system.
Explanation of safety symbols and their meanings.
Prohibited actions and environments for safe operation.
Mandatory steps and checks for safe operation.
Historical background of the Unimog vehicle.
Detailed description of the FMS 1:24 Unimog 421 model.
Key features and specifications of the model.
Technical specifications including dimensions and performance.
Introduction to the 2.4GHz AFHDS 2A-BS system.
Overview and labeling of the receiver components.
Explanation of the receiver's LED status indicators.
Description of the receiver's interface ports.
Information about the external receiver antenna.
Information about the built-in transmitter antenna.
Guidelines for installing the receiver and servos.
Instructions and precautions for installing transmitter batteries.
Explanation of the transmitter's LED status indicators.
Procedure for binding the transmitter and receiver.
Steps for calibrating the transmitter's control sticks.
Procedure for powering off the system safely.
Overview of system functions available on the transmitter.
Description of channel assignments and their functions.
Explanation and setting of the drag brake function.
Adjusting trims and travel for the gear shift servo.
How to reverse channel output direction for steering and throttle.
Adjusting the trim values for channels CH1 and CH2.
Adjusting the travel range (D/R) for channels CH1 and CH2.
Setting up the failsafe function for safety.
How to reset transmitter function data to default.
Explanation of the idle alarm state.
Explanation of the transmitter's sleep mode.
Low voltage alarm state for the transmitter.
Offline prompt state when receiver is disconnected.
Critical precautions for installing and operating the product.
Receiver's low voltage and overheating protection functions.
Detailed specifications of the FMS-G3 transmitter.
Detailed specifications of the FMS-R3A receiver.
Guide on connecting the battery to the vehicle's power system.
Important precautions for charging and handling LiPo batteries.
Exploded view of the oil shock absorbers assembly.
Exploded view of the wheels and related parts.
Exploded view of the transmission gear box assembly.
Exploded view of the front axle assembly.
Exploded view of the rear axle assembly.
Exploded view of the semi-finished chassis assembly.
Exploded view of the car hopper group.
Exploded view of the finished chassis assembly.
Exploded view of the finished hard body set.
Exploded view of the complete vehicle assembly.
To Next Page
