To Next Page

To Previous Page

104 FNM

HPE Series

10. Fill a tank with a proper mixture of fuel and injectors additive, like Bardahl

Injector Cleaner.

Connect the fuel suction hose to the tank return line. Run the engine for some minutes at the

minimum speed.

11. To prevent cylinders rusting, FNM

advises to spray or nebulize Vanguard

storage 30

protective oil (MIL-L-2104, MIL-L-21260A) through the suction manifold (dismounted air filter)

and spin the engine without starting it to facilitate oil suction (this operation can be carried out

by spinning the starter motor and consequently the engine with the fuel supply line

disconnected to avoid starting and to facilitate only the movement/lubrication of the internal

parts).

12. Disconnect the electrical connections. Push the red stop button on the ECU box .

13. Clean the engine metal parts and spray the engine metal parts and the engine leverages with a

protective/unlocking spray to prevent rust. FNM

advises to use Bardahl

K9spray.

14. Lubricate the starter pinion and the mechanical connections (grooved joints, etc.)

15. Dismount the belts and store them preventing their deformation.

16. Disconnect the fuel line (inlet and outlet).

17. Spray the electrical connections with electrical connections protective spray.

18. Store the engine in a well aerated place avoiding humidity and steam to prevent rust forming.

19. For long storage of fuel in tank, FNM

advises to use Bardahl

DAB or IOSSO

Diesel fuel

antibacterial additives to prevent the proliferation of algae and deposits.

FNM HPE Series User Manual

Other manuals for FNM HPE Series