12 FNM
®
HPE Series
- Before using the engine for the first time simulate a few trial maneuvers to identify the controls
and their main functions, especially those related to start -stop operations. Do not keep using
the engine if anomalies are detected.
- In case of anomaly, stop immediately the engine or reduce the speed as far as possible. Start
again only when the normal operating conditions are restored.
- Keep the engine and related components in conditions of maximum efficiency and carry out the
maintenance operations established by the manufacturer and repeated in this manual.
- Replace only original spare parts. Use only oil, lubricants and grease recommended by the
manufacturer in accordance with the specifications of this manual.
- Pay attention to the disposal of polluting residues (used oil, diesel fuel, etc.) following the local
legislation and disposal procedures.
- Do not unscrew the expansion tank cap of the cooling system when the engine is hot! Slowly
turn until any steam under pressure comes out, and then remove the cap.
- Do not start the engine without the air filter: the detachment of rotor parts of the compressor
during operation could cause damage to persons, furthermore any aspirated particles could
damage the blades. Avoid contact of hands with the rotor.
- Do not touch the turbocharger and the turbine cover with hands immediately after using the
engine, risk of burns. Let engine cool before interacting with the hot parts.
To Next Page
Loading...
Need help?
General
