FNM
®
HPE Series 41
2. on page 42) and then to position II when the light of the glow plugs turn off (Figure 13 - Hold
the key to position II until the engine starts. on page 43).
3. Let the engine warm up for few minutes at minimum RPM.
4. Carry out the engine diagnosis with the installer, so that it acquires the reference data. These
data must be copied into the installation form in order to validate the FNM
®
engine warranty.
5. Check for any leaks, verify the correct operation of the sea water pump, the proper flow of
water from the engine exhaust, all the lights on the instrument panel are off and there is no
audible alarm. Check also the oil pressure, coolant temperature and battery charging status.
6. If you heard strange noise, vibration or black smoke stop immediately the engine and refer to
assistance point.
7. Take the command of the boat.
8. Verify that all persons are on board and then engage the gear. Do not exceed the speed of the
engine during the first hours of operation!
On each occasion in which the engine is used for a long period at high revs, FNM
®
advises not to turn
it off at once, but to let it operate at low RPM without gear engaged for at least another two minutes in
order to facilitate gradual cooling of the stressed parts (turbine, etc..) avoiding any thermal stress.
To Next Page
Loading...
Need help?
General
