11
Default settings:
ON TIME (Thermostatic) TEMPERATURE: 21 °C (70 °F)
OFF TIME TEMPERATURE: “
” (pilot flame only)
TEMPERATURE SETTING:
1. Press button and hold until flashes. ON
and set temperature (setting in Thermostatic
Mode) displayed.
2. To continue press
button or wait. , OFF
displayed, temperature flashes.
3. Select off temperature by pressing the
or
button.
4. To confirm press
button.
NOTE: The on (Thermostatic) and off set temperatures are the same for
each day.
DAY SETTING:
5.
flashes. Press or button to choose
between
, , , , , , , , .
6. To confirm press button.
selected
ON TIME SETTING (PROGRAM 1):
7.
, 1, ON displayed, is displayed shortly,
and hour flashes.
8. To select hour press
or button.
9. To confirm press button. , 1, ON
displayed, displayed shortly, and
minutes flash.
10. To select minutes press or button.
11. To confirm press button.
OFF TIME SETTING (PROGRAM 1):
12.
, 1, OFF displayed, is displayed
shortly, and hour flashes.
13. To select hour, press
or button.
14. To confirm press
button. , 1, OFF
displayed,
displayed shortly, and
minutes flash.
15. To select minutes press or button.
16. To confirm press button.
NOTE: Either continue to PROGRAM 2 and set on and off times or stop
programming at this point, and PROGRAM 2 remains deactivated.
NOTE: PROGRAM 1 and 2 use the same on (Thermostatic) and off
temperatures for , and Daily Timer ( , , , , , , ). Once
a new on (Thermostatic) and / or off temperature has been set, that
temperature becomes the new default setting.
NOTE: If
, or Daily Timer are programmed for PROGRAM 1
and PROGRAM 2 on and off times, these become the new default
times. The batteries must be removed to clear the PROGRAM 1
and PROGRAM 2 on and off times and temperatures.
or Daily Timer ( , , , , , , ) selected
· Set on time and off time using same procedure as “ selected” (above).
· : Set on time and off time for both Saturday and Sunday.
· Daily Timer: Unique on and off times may be set for a single day of
the week, for multiple days of the week, or for every day of the week.
· Wait to finish setting.
L. AUXILIARY FEATURE
Upon ignition burner 1 is on and burner 2 is in the last setting.
ON:
To switch a burner ON, press the
button.
displayed.
OFF:
To switch the burner OFF, press the button.
disappears.
NOTE: The latching solenoid valve cannot operate manually. If the receiver
battery runs down it will remain in the last operating position.
M. ECO MODE
ON:
Press
button to enter Eco Mode.
displayed.
OFF:
Press
button. disappears.
User instructions
To Next Page
Loading...
