Need help?Do you have a question about the FODSPORTS V6S and is the answer not in the manual?
General| Brand | FODSPORTS |
|---|---|
| Model | V6S |
| Category | Intercom System |
| Language | English |
Describes charging lights (red flashing, blue full) and initial charging needs.
Use a qualified 5V/1A±0.5A charger to prevent damage to the device.
Charge at least once every 2 months if the product is not used for a long time.
Insert the clip mounting bracket between the helmet's internal padding and external shell.
If bracket mounting is difficult, use the 3M tape bracket; adhere and press for 15 seconds.
3M tape mounting is optional; FODSPORTS is not responsible for risks associated with its use.
Mount the button microphone to the velcro pad in the nose section, left of center for full helmets.
For open face helmets, point the microphone's triangular mark towards your mouth.
Place speakers in cheek pads, push firmly, and tuck wires into helmet liner gaps.
Slide the V6S main unit onto the bracket until it clicks firmly into the bottom portion.
To detach the V6S unit from the bracket, push it upwards.
Press and hold the Power button for approximately 3 seconds to switch the device on or off.
Check battery level by double-pressing the Power button; low battery alerts are given every 5 minutes.
Instructions for answering, rejecting, ending calls, and redialing the last number.
Adjust volume and switch between automatic/manual call answering modes.
Activate Siri or S-Voice by double-clicking the Volume - button for hands-free dialing.
Control music playback: play, pause, next track, previous track, and volume adjustment.
Turn FM radio on/off, adjust volume, and search for channels.
Turn intercom on/off, adjust volume, and exit intercom mode.
Reset intercom memory and change voice prompt language (English/Japanese).
Steps to pair V6S with a mobile phone via Bluetooth, including PIN entry if required.
Pair with Bluetooth GPS navigation; procedure is similar to mobile phone pairing.
Connect up to 6 V6S units for full duplex intercom communication.
Steps to pair two V6S units using Button B and initiate intercom conversation.
Steps to pair three V6S units using Buttons B and C, then initiate intercom.
Steps to pair four V6S units using Buttons B, C, and D, then initiate intercom.
Steps to pair five V6S units using Buttons B, C, D, and E, then initiate intercom.
Steps to pair six V6S units using Buttons B, C, D, E, and Power button, then initiate intercom.
How to answer an incoming intercom call during an active conversation.
To Next Page
