To Next PageTo Next Page
Need help?Do you have a question about the Fogo & Chama HEAT-481-SS and is the answer not in the manual?
General| Brand | Fogo & Chama |
|---|---|
| Model | HEAT-481-SS |
| Category | Heater |
| Language | English |
Avoid electric shocks by keeping the appliance away from water and not inserting metallic items.
A damaged power cable must be replaced by the manufacturer or an authorized technician.
Do not use the heater if it is damaged.
Unplug the cable from the electric socket only after the heater has stopped functioning.
Never leave the heater working unattended and ensure it stops before dismantling.
Details children's age-based usage restrictions, supervision, and operational limitations.
Dispose of this product separately as electronic waste, not with municipal rubbish.
Be aware that some parts can become very hot and cause burns, especially near children.
The appliance must not be covered with any insulating or similar material.
The heater must not be located immediately below a socket-outlet.
Ensure the power supplied complies with the unit's electrical requirements to prevent damage.
Do not use the heater in areas with flammable objects, gas, or dust.
Avoid touching the heater while it is working to prevent burns.
Do not place any objects on the heater's surface while it is operating.
Avoid placing the heater in bathrooms or similar indoor locations to prevent electric shocks.
Do not use the heater with automatic sequencers, timers, or similar devices.
Turn off all switches and unplug the heater if an emergency situation occurs.
Contact the seller for malfunctions; do not attempt self-repair.
Cleaning and user maintenance must not be performed by children without supervision.
Non-user replaceable light sources must be handled by qualified personnel.
Verify all parts are present before proceeding with installation, starting with fixing the base.
Connect to the heater via Bluetooth and select 'Warm Vibe' in the device list.
Always turn off and unplug the heater before cleaning with a damp cloth.
Do not put the heater directly into any container with water.
Check the power cord connection if the heater does not emit heat after turning on.
A small amount of smoke and smell during first use is normal due to protective oil evaporation.
