Ford 1996 Contour - Page 92

90
%
*
[SC09200(ALL)06/95]
Accelerating With the Speed Control Operating
*
[SC09300(ALL)05/95]
You can use the accelerator pedal to speed up momentarily.
When you take your foot off the accelerator, the vehicle will
return to the set speed.
*
[SC09400(ALL)01/95]
Resetting the Speed Control
*
[SC09410(ALL)03/95]
To reset the speed control to a lower speed, use one of the
following procedures:
*
[SC09415(ALL)03/95]
■ COAST — Press and hold the COAST switch. Release the
switch when the vehicle slows down to the desired speed.
[SC09420(ALL)05/94]
■ Tap the brake pedal. When the vehicle attains the desired
speed, press the SET ACC switch and release it immediately.
[SC09427(ALL)05/94]
■ TAP-DOWN — Press and then quickly release the COAST
switch. Each time you “tap” the switch, the set speed will
decrease by 1 mph (1.6 km/h).
*
[SC09430(ALL)05/95]
If vehicle speed is reduced below 30 mph (50 km/h) by any of
the above methods, then you must manually accelerate to a
speed over 30 mph (50 km/h) and reset the system.
*
[SC09435(ALL)03/95]
To reset the speed control to a higher speed, follow one of
these procedures:
[SC09440(ALL)05/94]
■ ACC — Press and hold the SET ACC switch. Release the
switch when the vehicle has accelerated to the desired speed.
[SC09445(ALL)03/95]
■ Depress the accelerator pedal. When the vehicle attains the
desired speed, press and release the SET ACC switch.
[SC09452(ALL)05/94]
■ TAP-UP — Press and then quickly release the SET ACC
switch. Each time you “tap” the switch, the set speed will
increase by 1 mph (1.6 km/h).
File:cdsco.ex
Update:Thu Jan 25 12:10:03 1996