steering pump. The other is located just above where exhaust manifold (9430) and three-way
catalytic converter (TWC) connect.
26. Remove nuts and disconnect front stabilizer bar from front suspension lower arms. Discard nuts.
27. Remove disc brake calipers as outlined in Section 06
-03 and secure to suspension upper arms.
28. Disconnect fuel lines along left frame rail near engine mounts as outlined in Section 03-04B .
29. Position a jack under front suspension lower arm and raise arm until tension is applied to front coil
spring. Remove pinch bolt and nut retaining spindle to upper control arm ball joint. Slowly lower jack
under front suspension lower arm to disconnect spindle from ball joint.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B39.HTM~gen~ref.HTM
To Next Page
Loading...
