Ford 1997 Ranger - Page 130

drive belt over the radiator.
9. Remove the fan shroud retaining bolts. Using Strap Wrench D85L-6000-A or equivalent to hold the
water pump pulley, remove the fan blade and fan clutch assembly. Remove the fan blade and fan
shroud as an assembly.
10. Remove the radiator overflow hose from the radiator and position it out of the way. Remove the
accessory drive belt.
11. Compress the clamp on the lower radiator hose and disconnect the hose from the radiator.
12. Disconnect the automatic transmission oil cooling lines from the radiator fittings. Install protective
caps over the lines.
13. Remove the radiator bolts. Tilt the radiator back and lift it directly upward, clear of the radiator support
bracket.
Item Part Number Description
1 3F671 Belt Idler Pulley
2 19D629 A/C Compressor
3 3D673 Power Steering Pump Pulley
4 6B209 Drive Belt Tensioner
5 6312 Crankshaft Pulley
6 8A528 Water Pump Pulley
7 10300 Generator
Page
3
of
12
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B40.HTM~gen~ref.HTM
tomsn048@gmail.com