6. Remove 4 screws retaining crankshaft pulley (6312) and remove pulley.
7. Remove bolt and washer retaining crankshaft damper to crankshaft.
8. Remove crankshaft vibration damper from crankshaft (6303) using Crankshaft Damper Remover
T58P-6316-D and Damper Remover Adapter T82L-6316-B.
9. Drain engine oil from crankcase.
10. Remove oil pan (6675) as outlined in this section and discard oil pan gasket (6710).
11. Lower vehicle.
Fastener Location, Water Pump Front Cover
S309
4 3A733 Power Steering Pump Pulley
5 6B209 Drive Belt Tensioner
6 N606068-
S309
Bolt
7 3F671 Power Steering Belt Idler Support
A — Tighten to 40-55 Nm
(30-41 Lb-Ft)
B — Pulley with Pull-Off Groove Facing Front, Flush with
End of Shaft + /- .25mm
(0.018 Inch)
C — Tighten to 30-50 Nm
(22-37 Lb-Ft)
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B21.HTM~gen~ref.HTM
To Next Page
Loading...
