Ford 1997 Ranger - Page 49

a
Apply Pipe Sealant with Teflon D8AZ-19554-A or equivalent meeting Ford specifications WSK-
M2G350-AZ and ESR-M18P7-A to fastener threads.
12. Remove remaining bolts in engine front cover and remove cover. Discard old engine front cover
gasket (6020).
13. Pry crankshaft front seal (6700) from engine front cover with a flat-blade screwdriver or similar tool.
Use care to prevent damage to engine front cover.
14. While timing cover is off, inspect timing chain and sprockets to ensure continued service as outlined
in Section 03
-00 .
Installation
CAUTION: Aluminum components gouge easily, which may result in gasket leaks. Always use
care when servicing aluminum gasket surfaces.
Engine Front Cover
NOTE: Lightly oil all bolt threads except those requiring special sealants.
1. If crankshaft front seal is to be replaced, follow instructions outlined in this section.
2. Clean gasket surfaces on cylinder blocks and engine front cover.
11 N804576-
S8
M6 x 1.0 x 28.5 8-12 6-8
12 N804576-
S8
M6 x 1.0 x 28.5 8-12 6-8
13 N804576-
S8
M6 x 1.0 x 28.5 8-12 6-8
14 N804576-
S8
M6 x 1.0 x 28.5 8-12 6-8
15 N804576-
S8
M6 x 1.0 x 28.5 8-12 6-8
Page
7
of
10
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B21.HTM~gen~ref.HTM
tomsn048@gmail.com