Ford 1997 Ranger - Page 60

 Cylinder No. 1 Intake
 Cylinder No. 2 Exhaust
 Cylinder No. 4 Intake
 Cylinder No. 5 Exhaust
Tighten rocker arm bolts to 11 Nm (8 lb-ft).
21. For valves in above step, check rocker arm-to-valve clearance. Clearance should be 2.15-4.69mm
(0.084-0.184 in.).
Camshaft Position A — Rocker Arm, Push Rod, and Fulcrum Installation
22. Rotate engine so camshaft is in Position B, as shown, with camshaft sprocket timing mark at two
o'clock position and crankshaft sprocket timing mark at 4:30 position.
23. NOTE: Lubricate each push rod, rocker arm, and rocker arm fulcrum with Engine Assembly
Lubricant D9AZ-19579-D or equivalent meeting Ford specification ESR-M99C80-A before
installing.
Item Part Number Description
1 — Centerline of Keyway Vertical Within Five Degrees
2 — Camshaft Sprocket Timing Mark at Top Center
3 — Crankshaft Sprocket Timing Mark at Top Center
4 6564 Rocker Arm, No. 1 Intake
5 6565 Push Rod
6 6A528 Rocker Arm Fulcrum
7 6A527 Rocker Arm Bolt
8 6564 Rocker Arm and Parts
9 6564 Rocker Arm and Parts
10 6564 Rocker Arm and Parts
A — Tighten to 11 Nm
(8 Lb-Ft)
Page
5
of
10
1997 Aerostar/Ranger
2011
-
04
-
27
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B23.HTM~gen~ref.HTM
tomsn048@gmail.com