4. Install spark plugs. Tighten to 11 Nm (8 lb-ft).
5. Install EGR tube flare nut into exhaust manifold connector (9F485) (Aerostar) finger tight.
6. Install EGR tube flare nut into EGR valve finger-tight.
7. Install bolt in EGR valve to exhaust manifold tube at exhaust manifold and tighten to 20-30 Nm (15-22
lb-ft).
8. Tighten flare nuts to 35-65 Nm (26-48 lb-ft).
9. Connect two Delta PFE sensor hoses onto ports in EGR tube.
10. Connect exhaust inlet pipe to left exhaust manifold and right exhaust manifold. Tighten retaining nuts
to 41 Nm (30 lb-ft). Tighten both nuts in equal amounts to correctly seat inlet pipe flange.
11. NOTE: When the battery has been disconnected and reconnected, some abnormal drive
symptoms may occur while the powertrain control module (PCM) (12A650) relearns its
adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the
strategy.
Connect ground cable at battery.
12. Start engine and check for oil and exhaust leaks.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B24.HTM~gen~ref.HTM
To Next Page
Loading...
