13. Install oil pan as outlined in this section.
14. CAUTION: If a new distributor or camshaft position sensor is installed, run engine at idle
for five minutes before driving vehicle.
Dip entire distributor or camshaft position sensor drive gear in Engine Assembly Lubricant D9AZ-
19579-D or equivalent meeting Ford specification ESR-M99C80-A.
15. Pour the rest of the pint of Engine Assembly Lubricant D9AZ-19579-D or equivalent meeting Ford
specification ESR-M99C80-A through distributor hole onto cam drive gear.
16. For Ranger, install camshaft position sensor. Refer to Section 03
-14 , Engine Controls, Electronic, for
fuel injection timing.
17. Install cylinder heads as outlined in this section.
18. Install and perform intake manifold installation procedures as outlined in this section.
19. Fill crankcase with specified amount and viscosity of engine oil.
20. Fill and bleed cooling system.
21. NOTE: When the battery has been disconnected and reconnected, some abnormal drive
symptoms may occur while the powertrain control module (PCM) (12A650) relearns its
adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the
strategy.
Connect ground cable at battery.
22. Start engine and check for oil, exhaust, coolant and vacuum leaks.
23. Check and set initial ignition timing.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B30.HTM~gen~ref.HTM
To Next Page
Loading...
