412-02-17 Heating and Ventilation 412-02-17
REMOVAL AND INSTALLATION (CONTINUED)
E1245 EN 07/2001 2002 Bantam
5. Remove the bulkhead extension
(continued).
• Remove the single screw.
NOTE: Plug the heat exchanger.
6. Remove the heater control valve.
1. Disconnect the plug from the heater
control valve.
2. Undo the four clamps and detach the
coolant hoses.
Installation
NOTE: Only carry out steps 1 to 4 if there is a
regular knocking noise coming from the fascia
crash padding when the heater control is set to
between Min and Max.
1. NOTE: Coolant will escape.
Remove the left-hand heater coolant hose
(shown without refrigerant line).
1. Disconnect the plug.
2. Remove the left-hand heater coolant
hose.
To Next Page
Loading...
