The bed extender should always be kept in the stowed position
with the tailgate closed when not in use.
To remove the bed extender:
1. Extend the bed extender.
2. Pull the round knobs on each side
of the extender to unlock it.
Make sure the locking clip screws
are loose before removing the
extender.
1. Press the locking clips below the
middle bar on each side and lift the
extender out of the bed.
To install the bed extender, follow
the removal procedure in reverse
order.
TAILGATE LOCK (IF EQUIPPED)
Your vehicle may be equipped with a tailgate lock designed to prevent
theft of the tailgate.
• Open the rear tonneau cover.
• Lower the tailgate.
• Move the lock lever to the up
position on each side of the
tailgate.
Driver Controls
100
To Next Page
Loading...
Need help?
General
