Engine coolant temperature
gauge: Indicates engine coolant
temperature. At normal operating
temperature, the needle will be in
the normal range (between “H” and
“C”). If it enters the red section,
the engine is overheating. Stop
the vehicle as soon as safely
possible, switch off the engine and let the engine cool.
Never remove the coolant reservoir cap while the engine is
running or hot.
Odometer: Registers the total miles (kilometers) of the vehicle.
• Without Message Center
To switch the display from Metric to
English, press and hold the button
on the cluster for three seconds.
• With Message Center
Refer to Message Center in the
Driver Controls chapter on how to
switch the display from Metric to
English and the odometer to the
speedometer.
Trip odometer: Registers the miles (kilometers) of individual journeys.
• Without Message Center
Press and release the button on the
cluster to toggle between odometer
and trip odometer display. To reset,
press the button again until the trip
reading is 000000.0 miles.
2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Instrument Cluster
15
To Next Page
Loading...
Need help?
General
