Changing engine oil and filter
Change your oil and filter according to the scheduled maintenance
information in this supplement. Change more frequently if your vehicle
operation includes extended periods of idling or low-speed operation,
driving for a long time in cold temperatures or driving short distances.
See the following section Engine lubrication for severe service
operation for all severe duty restrictions.
Use Ford Engine Oil Filter Part No. 3C3Z-6731–AA (FL–2016) or
equivalent. These filters protect your engine by filtering harmful,
abrasive or sludge particles. The FL–2016 filters particles significantly
smaller than most available “will-fit” filters.
To replace the filter,
1. Unscrew the oil filter cap and wait a few seconds for the oil to drain
through the built-in drain valve. Note: The filter should be changed
before reinstalling the oil pan drain plug.
2. Reinstall and tighten the oil filter cap.
Do not handle a hot oil filter with bare hands.
Continuous contact with USED motor oil has caused cancer in
laboratory mice. Protect your skin by washing with soap and
water.
Engine lubrication for severe service operation
The following severe service operating conditions require unique engine
maintenance procedures:
• towing a trailer over 1,000 miles (1,600 km)
• sustained, high speed driving at Gross Vehicle Weight Rating
(maximum loaded weight for vehicle operation during hot
weather-above 90°F [32°C]).
• frequent or extended idling (over 10 minutes per hour of normal
driving).
• operating in severe dust conditions.
• frequent, short trips of 10 miles (16 km) or less during freezing
weather
2007 Econoline (eco)
Supplement
USA (fus)
Maintenance and Specifications
39
To Next Page
Loading...
