6. Recirculated air: Press to activate/deactive air recirculation in
the vehicle. Recirculated air may reduce the amount of time needed to
cool down the interior of the vehicle and may also help reduce undesired
odors from reaching the interior of the vehicle. Recirculation can be
engaged manually in any airflow selection except defrost. Recirculation
may turn off automatically in some airflow modes to reduce fog potential.
7. A/C: Press to activate/deactivate air conditioning. Use with
recirculated air to improve cooling performance and efficiency. Engages
automatically in AUTO,
(defrost) and (floor/defrost).
8.
Manual override controls: Allows you to manually select where
airflow is distributed. Press to toggle through the air distribution modes
listed below. The selected mode will illuminate in the display. To return
to full automatic control, press AUTO.
: Distributes air through the windshield defroster vents, demister
vents, floor vents and rear seat floor vents. The system will automatically
provide outside air to reduce window fogging.
: Distributes air through the floor vents and rear seat floor vents.
The system will automatically provide outside air to reduce window
fogging. Note: You may notice a small amount of air flowing from the
defroster vents and demister vents.
: Distributes air through the instrument panel vents, center console
vents, floor vents and rear seat floor vents.
: Distributes air through the instrument panel vents and center
console vents.
9.
Driver heated seat control: Press to control the driver heated
seat. Refer to Heated seats in the Seating and Safety Restraints
chapter for more information.
10.
Fan Speed: Press to manually increase or decrease the fan
speed. To return to automatic fan operation, press AUTO.
11. OFF: Outside air is shut out and the fan will not operate.
12. Driver side temperature control: Press to increase/decrease the
temperature on the driver side of the vehicle in dual zone or the
temperature of both the driver and passenger side in single zone.
13. AUTO: To engage automatic temperature control, press AUTO and
select the desired temperature using the temperature control. The
system will automatically determine fan speed, airflow distribution, A/C
on or off, and outside or recirculated air, to heat or cool the vehicle to
reach the desired temperature.
2007 Edge (edg)
Owners Guide (post-2002-fmt)
USA (fus)
Climate Controls
71
To Next Page
Loading...
Need help?
General
