Item Capacity
Ford part name or
equivalent
Ford part number /
Ford Specification
Windshield washer fluid 2.7 quarts (2.6L)
Motorcraft Premium
Windshield Washer
Concentrate
ZC-32-A /
WSB-M8B16-A2
Fuel tank
16.5 gallons
(62.5L)
——
1
Add the coolant type originally equipped in your vehicle.
2
Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the
requirements of Ford specification WSS-M2C930-A and the API Certification mark.
3
The Power Transfer Unit is lubricated for life with synthetic lube. Lubricant levels are not to be
checked or changed unless a leak is suspected or repair required. Replace Power Transfer Unit
lubricant with specified synthetic lubricant anytime the unit is submerged in water.
4
Fill to 1/4 inch to 9/16 inch (6 mm to 14 mm) below bottom of fill hole.
5
4X4 vehicles exposed for prolonged periods to temperatures less than -40° F (-40° C) should
change out the rear axle fluid to Motorcraft SAE 75W-140 Synthetic Rear Axle Lubricant, Ford part
number XY-75W140-QL meeting Ford specification WSL-M2C192-A.
6
Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and
if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set
by the indication on the dipstick’s normal operating range.
7
Automatic transmissions that require MERCON威 V should only use MERCON威 V fluid or fluid that
is specified dual usage MERCON威/MERCON威 V. Refer to scheduled maintenance information to
determine the correct service interval. Use of any fluid other than the recommended fluid may
cause transmission damage.
8
Service refill capacity is determined by filling the transmission to the bottom of the filler hole with
the vehicle on a level surface.
2008 Escape (204)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
292
To Next Page
Loading...
