110
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
IN AN
EMERGENCY
❒
for the vehicles equipped with alloy
rims, remove the pressure-fitted hub
cap using the supplied screwdriver;
❒
loosen by about one turn the bolts
on the wheel to be replaced, using
the wrench E-fig. 5;
❒
turn the jack crank to open it
partially;
❒
loosen the clamping device
B-fig. 4;
❒
take out the tool container C
and take it near to the wheel
to be changed;
❒
take the space-saver wheel D;
❒
to remove the hub cap use the
supplied screwdriver, prising on
the special slit on the outer rim;
fig. 5
KA00064m
fig. 4
KA00063m
To change a wheel proceed as follows:
❒
stop the car in a position so that it
is not a danger for on-coming traffic
and where you can replace the wheel
safely. The ground must be flat and
sufficiently compact;
❒
switch the engine off and pull up
the handbrake.
❒
engage the first gear or reverse;
❒
lift the luggage compartment mat
A-fig. 3;
fig. 3
To Next Page
Loading...
