112
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
IN AN
EMERGENCY
REFITTING THE STANDARD
WHEEL
Following the procedure described
previously, raise the car and remove
the space-saver wheel.
Versions with steel rims
Proceed as follows:
❒
make sure the contact surfaces
between standard wheel and hub
are clean so that the fastening bolts
will not come loose;
❒
fit the standard wheel inserting
the four bolts into the holes;
❒
using the wrench provided, tighten
the fastening bolts;
❒
pressure-fit the hub cap, aligning
the special groove (on the cap itself)
with the inflation valve;
❒
lower the car and remove the jack;
❒
using the wrench provided, fully
tighten the bolts in the sequence
shown previously.
Versions with alloy wheels
❒
place the wheel onto the hub and
tighten the bolts using the wrench
provided;
❒
lower the car and remove the jack;
❒
using the wrench provided, fully
tighten the bolts in the sequence
shown in fig. 8;
❒
reinstall the pressure-fitted hub cap,
making sure that the reference hole
on the wheel is aligned with the
reference hole on the cap.
IMPORTANT If it is not fitted properly,
the hub cap may detach when the
vehicle is running.
❒
fit the space-saver wheel, ensuring
that the pin N-fig. 7 is aligned
with one of the wheel holes O;
❒
tighten the four fastening bolts;
❒
turn the jack handle to lower
the car and remove the jack;
❒
fully tighten the bolts, passing
alternatively from a bolt to
the opposite one, following
the order indicated in fig. 8.
fig. 7
To Next Page
Loading...
