KA00128m
The kit in fig. 9 includes:
A Label
B Sealant bottle
C Hose of the sealant bottle
D Bottle support
E Pressure gauge
F Power plug with cable
G Compressor switch
H Repair kit hose
I Safety valve
1. Remove the tyre repair kit from
the package.
2. Remove the label A indicating
the max. allowed speed of 80 km/h
(50 mi/h) from the sealant bottle
and place it on the dashboard in
the driver’s field of vision. Make sure
the label does not cover anything
important.
3. Remove the hose H with the safety
valve I and the power plug with cable
F from the kit.
4. Connect the hose H with the safety
valve I to the sealant bottle B.
5. Fasten the sealant bottle B on
its support D.
6. Remove the cap of the valve from
the damaged tyre.
7. Tightly screw the hose of the sealant
bottle C on the valve of the damaged
tyre.
8. Make sure the switch of the
compressor G is in position 0.
9. Insert the power plug F in the socket
of the cigar lighter or in an auxiliary
supply socket.
10. Start the engine.
11. Set the switch of compressor G
in position I.
12. Inflate the tyre for max. 10 minutes
at a pressure between min. 1.8 bar
(26 psi) and max. 3.5 bar (51 psi).
Move the switch of compressor
G in the position 0 and check
the current pressure of the tyre
with the pressure gauge E.
Note If a pressure of 1.8 bar (26 psi)
cannot be reached, do not continue
inflating the tyre.
Note If the sealant is pumped through
the valve of the tyre, the pressure can
increase up to 6 bar (87 psi), but will
decrease again after about 30 seconds.
105-132 Ford KA EN 08/04/14 08:39 Pagina 116
To Next Page
Loading...
