Ford 2008 Ka - Page 123

122
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
IN AN
EMERGENCY
MAIN BEAM/DIPPED
HEADLIGHTS
To change the bulb, proceed as follows:
❒ remove the protecting rubber cap
mentioned above;
❒ press on the central electrical
connector A-fig. 17 and withdraw
the unit;
❒ remove the bulb B and replace it;
❒ fit the new bulb, aligning the outlines
of the metallic part with the grooves
on the reflector;
❒ refit the bulb holder catches and
reconnect the electrical connector;
❒ refit the cap A, ensuring that it locks
into place.
To change the bulb, proceed as follows:
❒ lever the lens off, by initially applying
force from the front towards the
back (1-fig. 16a);
❒ then lever in the opposite direction,
by applying force from the back part
(2-fig. 16b) and remove unit B
❒ turn the bulb holder
counterclockwise, remove the snap-
fitted bulb and replace it;
❒ reinstall the bulb holder into the lens,
then install the unit B making sure
that the fixing clip has clicked.
fig. 17
KA00089m
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒ turn the bulb holder clockwise
A-fig. 15 and withdraw it;
❒ remove the bulb B pushing it gently
and turning counterclockwise
(bayonet fitting), then replace it;
❒ refit the bulb holder A by turning it
clockwise and locking it properly;
Side
WARNING The intervention must
be carried out taking all precautions
necessary to avoid damaging the
bodywork (please use a sufficiently rigid
and appropriately thick plastic card).
fig. 16a
1
KA00153m
fig. 16b
KA00154m
fig. 15
KA00087m
105-132 Ford KA EN 08/04/14 08:39 Pagina 122