EasyManua.ls Logo

Ford 2008 Ka - Page 138

Ford 2008 Ka
173 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
137
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
SERVICING
AND CARE
WINDSCREEN/REAR WINDOW
WASHER FLUID fig. 1-2
To add fluid, remove the cap D,
pressing the special tab.
Check fluid level through the reservoir.
Close the cap D pressing its central
section.
Do not travel if the
windscreen washer
reservoir is empty: using the
windscreen washer is essential
for improving visibility.
Some commercial windscreen
washer additives are flammable.
The engine compartment contains
hot parts which could cause a fire
if they come into contact with
these additives.
WARNING
BRAKE FLUID fig. 1-2
Undo the cap E: and check that the
liquid contained in the reservoir is
at the maximum level.
Fluid level in the reservoir must not
exceed the MAX mark.
Use the brake fluid shown in
the “Fluids and lubricants” table
(see section “Technical Specifications”)
to top up.
Note Carefully clean the cap of
reservoir E and the surrounding surface.
Take great care to ensure that
impurities do not enter the reservoir
when the cap is opened.
For topping-up, always use a funnel
with integrated filter with mesh equal
to or lower than 0.12 mm.
IMPORTANT Brake fluid is hygroscopic
(i.e. it absorbs moisture). For this
reason, if the car is mainly used in areas
with a high degree of atmospheric
humidity, the fluid should be replaced at
more frequent intervals than specified in
the “Service schedule”.
Prevent brake fluid which
is highly corrosive from
coming into contact with
painted parts. Should this
occur, immediately wash with water.
Brake fluid is poisonous
and highly corrosive.
In the event of accidental contact,
immediately wash the affected
parts with water and neutral soap.
Then rinse thoroughly. In case
of swallowing immediately call
a doctor.
WARNING
The symbol π, on the
container, indicates a
synthetic brake fluid, which is
different from a mineral fluid.
Use of a mineral type fluid will
damage the special rubber seals of
the braking system beyond repair.
WARNING
133-146 Ford KA EN_131-148 Ford KA IT 08/04/14 08:39 Pagina 137

Table of Contents

Related product manuals