18
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
Speed Beep (Speed limit)
This function is used to set the car
speed limit (km/h or mph); the driver
is immediately alerted when this limit
is exceeded (see chapter “Warning
lights and messages”).
To set the desired speed limit, proceed
as follows:
– briefly press button MENU
N
,
the display will show the message
(Speed Buzz);
– press button + or − to select speed
limit activation (On) or deactivation
(Off);
– if the function has been activated (On),
press buttons + or − to select
the required speed limit and then
press MENU
N
to confirm.
Note. The speed may be set in the range
from 30 to 200 km/h, or from 20 to
125 mph according to the previously
chosen unit (see “Setting the distance
unit” paragraph ) described below.
The setting will increase/decrease by five
units each time the button +/
−
is pressed.
Hold the button +/
−
pressed to increase/
decrease the setting rapidly
and automatically. Complete the setting
by single pressing the button when
you approach the required value.
Trip B data (Trip B enablement)
This function can be used to activate
(On) or deactivate (Off) the Trip
B display (partial trip).
For further information see “Trip
computer”.
Proceed as follows to switch
the function on and off:
– briefly press button MENU
N
:
(On) or (Off) will flash on the display
(according to previous setting);
– press the button + or − to select;
– briefly press button MENU
N
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
– briefly press button MENU
N
to go back to the menu screen or press
the button for long to go back to the
standard screen without storing settings.
To cancel the setting, proceed as follows:
– briefly press button MENU
N
:
(On) will flash on the display;
– press the button −, “Off” flashes
on the display;
– briefly press button MENU
N
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
001-025 Ford KA EN 10/04/14 11:33 Pagina 18
To Next Page
Loading...
