Ford 2009 Econoline - Page 75

150,000 miles (240,000 km)
❑
Change engine oil and replace oil filter
❑
Replace engine- and frame-mounted fuel filters
❑
Replace accessory drive belt(s) (if not replaced in the last
100,000 miles [160,000 km])
❑
Replace front wheel bearing and wheel bearing grease seals
(if non-sealed bearings)
❑
Change Premium Gold coolant (see Motorcraft Premium Gold
Coolant Change Record)
❑
Change rear wheel drive (RWD) axle fluid - DANA axles not
using synthetic fluid only
❑
Rotate tires, inspect tires for wear and measure tread depth
and inspect wheel ends for endplay and noise (vehicles with
dual rear wheels should only rotate if unusual wear is noted)
❑
Inspect air filter restriction gauge, replace filter as required
❑
Inspect and lubricate steering linkage, ball joints, suspension,
tie rod ends, driveshaft and U-joints (lubricate if equipped
with Zerk fittings)
❑
Inspect engine cooling system level, coolant strength and
hoses
❑
Inspect brake pads, shoes, rotors, drums, brake lines and
hoses and parking brake system.
❑
Inspect exhaust system and heat shields
❑
Inspect automatic transmission fluid level
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
2009 Econoline (eco)
Supplement, 1st Printing
USA (fus)
Scheduled Maintenance: E-Series
75