Ford 2010 Econoline - Page 68

22,500 miles (36,000 km)
❑
Change engine oil and replace oil filter
❑
Rotate tires, inspect tires for wear and measure tread depth
and inspect wheel ends for endplay and noise (vehicles with
dual rear wheels should only rotate if unusual wear is noted)
❑
Inspect air filter restriction gauge, replace filter as required
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
30,000 miles (48,000 km)
❑
Change engine oil and replace oil filter
❑
Replace engine- and frame-mounted mounted fuel filters
❑
Rotate tires, inspect tires for wear and measure tread depth
and inspect wheel ends for endplay and noise (vehicles with
dual rear wheels should only rotate if unusual wear is noted)
❑
Inspect air filter restriction gauge, replace filter as required.
❑
Inspect and lubricate steering linkage, ball joints, suspension,
tie rod ends, driveshaft and U-joints (lubricate if equipped
with Zerk fittings)
❑
Check engine cooling system level, coolant strength (anti-
freeze & anti-corrosion) and hoses
❑
Inspect brake pads, shoes, rotors, drums, brake lines and
hoses and parking brake system
❑
Inspect exhaust system and heat shields
❑
Inspect automatic transmission fluid level
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
37,500 miles (60,000 km)
❑
Change engine oil and replace oil filter
❑
Rotate tires, inspect tires for wear and measure tread depth
and inspect wheel ends for endplay and noise (vehicles with
dual rear wheels should only rotate if unusual wear is noted)
❑
Inspect air filter restriction gauge, replace filter as required
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
Scheduled Maintenance: E-Series
68
2010 Econoline (eco)
Supplement (supplement), 1st Printing
USA (fus)