Condition Potential Causes
I accidentally programmed
all keys as MyKeys™
• Vehicle has a non Ford-approved remote
start system that is recognized as an
Admin key. Refer to the Using MyKey™
with remote start systems section to reset
all MyKeys™ as Admin keys.
No MyKey™ function with
(if equipped) intelligent
access key with push
button start
• An Admin intelligent access key is
present at a push-and-start vehicle.
• No MyKeys™ are programmed to the
vehicle. Refer to Create a MyKey™
section.
• Vehicle has been started using a non
Ford-approved remote start system (as an
Admin key) then a MyKey™ is inserted
without restarting the engine.
MyKey™ pogrammed total
includes one additional key
• Unknown key has been programmed to
the vehicle as a MyKey™.
• Vehicle is equipped with a non
Ford-approved remote start system. Refer
to Using MyKey™ with remote start
systems section.
Admin keys programmed
total includes one
additional key
• Unknown key has been programmed to
the vehicle as Admin key.
• Vehicle is equipped with a non
Ford-approved remote start system. Refer
to Using MyKey™ with remote start
systems section.
MyKey™ distance does not
accumulate
• MyKey™ is not being used by the
intended user.
• MyKey™ system has been recently
cleared.
• Vehicles has been started using a non
Ford-approved remote start system (as an
Admin key) then a MyKey™ is inserted
without recycling the MyKey™ in ignition.
Locks and Security
133
2011 F-250/350/450/550 (f23)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
