Create a MyKey威
To program MyKey威 on one of the keys programmed to the vehicle,
insert the key that you want to make a MyKey威 into the ignition. Turn
the ignition on. Use the message center buttons to do the following:
1. Press SETUP until PRESS RESET TO CREATE MYKEY is displayed.
2. Press and release the RESET button. HOLD RESET TO CONFIRM
MYKEY will be displayed.
3. Press and hold the RESET button for two seconds until MARK THIS
AS RESTRICTED is displayed.
4. Wait until KEY RESTRICTED AT NEXT START is displayed.
MyKey威 is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey威 optional settings
section. If your vehicle is equipped with remote start, see the Using
MyKey威 with remote start systems section.
Note: The MyKey威 can be cleared within the same key cycle that it was
created, otherwise a standard key (administrator key) is required to
clear the MyKey威 programming. To clear all MyKeys威 go to Step 2 in the
Clear MyKey威 section.
Programming MyKey威 optional settings
Turn the ignition on using an admin key. To program the optional
settings, use the message center buttons to do the following:
1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.
2. Press and release the RESET button to display MyKey威 setup menus.
The first menu shown is:
MYKEY MAX MPH <80 MPH> OFF
3. If you don’t want to change the maximum speed setting, press the
SETUP button to display the next menu. The remaining menus appear as
follows with the default settings shown:
MYKEY MPH TONES 45 55 65 <OFF>
MYKEY VOLUME LIMIT <ON> OFF
MYKEY ADVTRAC CTRL ON <OFF>.
4. On any of the menus press RESET to highlight your choice with the
<…>.
5. Press SETUP to enter your choice. The next optional setting will be
displayed.
6. Repeat Steps 4 and 5 until you are done changing the optional
settings.
Locks and Security
124
2012 Flex (471)
Owners Guide, 2nd Printing
USA (fus)
To Next Page
Loading...
Need help?
General
