FCS-21200-12 2012 Focus Electric Emergency Response Guide Page 12 of 23
• Remove the retainer from the parking brake cable bracket, and position the
parking brake cable and bracket aside. Depress the release tab at the rear of the
service disconnect, and rotate the release handle approximately 45 degrees
towards the front of the vehicle. Depress the release tab again, and rotate the
release handle another 45 degrees to the fully released position. Pull out on the
handle to remove the lower service disconnect.
NOTE : The lower service disconnect is removed in the same fashion as the upper.
To gain access to the lower battery high-voltage service disconnect, raise the
rear of the vehicle using a suitable jack.
• The lower battery high-voltage service disconnect is located on the
passenger side of the vehicle near the rear tire.
HIGH-VOLTAGE SERVICE DISCONNECTS - CONTINUED
To Next Page
Loading...
