Ford 2013 Escape - Removing a Headlamp; Changing a Bulb

REMOVING A HEADLAMP
2
2
E142468
1. Make sure the headlamp control is in
the off position and open the hood.
2. Remove the two screws from the
headlamp assembly.
3. Carefully pull the headlamp assembly
as far as possible towards the front of
the vehicle to disengage it from the
lower fixing point.
4. Carefully lift the outer side of the
headlamp and remove it.
5. Disconnect the electrical connector.
CHANGING A BULB
WARNINGS
Switch the lamps and the ignition off.
Let the bulb cool down before
removing it.
Note: Only fit bulbs of the correct
specification.
Note: The following instructions describe
how to remove the bulbs. Fit replacements
in the reverse order unless otherwise stated.
Headlamp
Type 1
E159161
A
B
Low beam headlampA
High beam headlampB
Headlamp High Beam
E159163
1
3
1. Remove the cover.
2. Disconnect the electrical connector.
3. Turn the bulb counterclockwise and
pull it straight out to remove it.
Note: Do not touch the glass of the bulb.
177
Escape/Kuga (CBS)
Maintenance