SETUP
TBC MODE (if
equipped)
press and hold
the
SELECT/RESET
stem
Electric or EOH
LANGUAGE =
ENGLISH /
SPANISH /
FRENCH
English / Spanish / French
SYSTEM CHECK
RESET FOR
SYSTEM CHECK
press and hold
the
SELECT/RESET
stem
XXX% OIL LIFE
ENGINE HOURS (if enabled)
ENGINE IDLE HOURS
(if enabled)
CHARGING SYSTEM
BRAKE SYSTEM
TBC GAIN = XX.X or NO
TRAILER (if equipped)
TBC GAIN = XX.X or
OUTPUT = ////// (if equipped)
XXX MILES TO E
• OIL LIFE XXX% HOLD RESET = NEW: This displays the remaining oil
life. An oil change is required whenever indicated by the message
center and according to the recommended maintenance schedule. USE
ONLY RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SELECT/RESET stem to display OIL LIFE
XXX% HOLD RESET = NEW.
2. Press and hold the SELECT/RESET stem for two seconds and release
to reset the oil life to 100%.
To change oil life 100% value (if equipped):
3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
SELECT/RESET stem to change the oil life start value. Each release and
press will reduce the value by 10%.
• UNITS ENG / METRIC: Displays the current units in English or Metric.
• AUTOLOCK: This feature automatically locks all vehicle doors when
the vehicle is shifted into any gear, putting the vehicle in motion.
84 Information Displays
2014 Econoline (eco)
Owners Guide gf, 1st Printing, November 2012
USA (fus)
To Next Page
Loading...
Need help?
General
