2. Remove the negative battery cable.
3. Remove the positive battery cable.
4. Remove the two nuts from the clamp.
5. Remove the battery.
6. Install in the reverse order.
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
CHANGING THE WIPER
BLADES - LHD
Windshield Wiper Blades
Note: The windshield wiper blades are
different in length. If you install wiper blades
of the wrong length, the rain sensor may not
work correctly.
Changing the Windshield Wiper Blades
1. Lift the wiper arm up to its service
position (close to a 90 degree angle).
2. Firmly hold the wiper arm tip with one
hand and disassemble the old wiper
blade with your other hand.
3. To remove the wiper blade, press the
plastic adaptor (1) and pull (2) the
wiper blade.
139
Ecosport (CBW) Vehicles Built From: 01-12-2014 Vehicles Built Up To: 29-03-2015, CG3590en enGBR, Edition date: 08/2014, First Printing
Maintenance
To Next Page
Loading...
