2. Twist the screwdriver in the position
shown to start separating the two
halves of the remote control.
3. Twist the screwdriver in the position
shown to separate the two halves of
the remote control.
Note: Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
4. Carefully remove the battery with the
screwdriver.
5. Install a new battery (3V CR 2032) with
the + facing downward.
6. Assemble the two halves of the remote
control.
7. Install the key blade.
Remote Control Without a Folding
Key Blade
1. Press and hold the buttons on the
edges to release the cover. Carefully
remove the cover.
2. Remove the key blade.
3. Twist a flat bladed screwdriver in the
position shown to separate the two
halves of the remote control.
31
Ecosport (CBW) Vehicles Built From: 01-12-2014 Vehicles Built Up To: 29-03-2015, CG3590en enGBR, Edition date: 08/2014, First Printing
Keys and Remote Controls
To Next Page
Loading...
