CONVENIENCE
MYKEY
®
MyKey allows you to program certain
driving restrictions in order to promote
good driving habits. You can program
things such as speed restrictions and
limited volume levels. For complete
information, refer to the MyKey chapter
in your Owner’s Manual.
INTEGRATED KEYHEAD TRANSMITTER
Press once to lock all doors. Press
again to confirm all doors are closed.
• Press
once to unlock the driver’s
door. Press again within three
seconds to unlock all doors.
• Press
to sound the panic alarm.
Press again or switch on the ignition
to deactivate.
• Press
twice within three seconds
to unlatch the ligate window. With a
power ligate*, however, this button
will open or close the power ligate
or reverse its movement instead of
the ligate window.
• Car finder: Press
twice within three
seconds to locate your vehicle. The
horn will sound and the turn lamps
will flash.
SECURICODE™ KEYLESS
ENTRY KEYPAD
Lock or unlock the doors, or release the
ligate glass without using a key. You
can use the keypad with the factory-set,
5-digit entry code located on the owner’s
wallet card in the glove box. Additionally,
you can create up to five of your own
5-digit personal entry codes.
To lock all of the doors and ligate
Press and hold 7•8 and 9•0 at the same
time. For complete information, refer to
the SecuriCode Keyless Entry Keypad in
the Locks chapter of your Owner’s Manual.
RAIN-SENSING WIPERS
*
If switched on, your wipers will
automatically turn on when moisture
is present on the windshield. The wiper
speed will vary based on the amount of
moisture detected and the sensitivity
setting. Switch o your wipers to switch
o the rain-sensing feature.
Note: Make sure that this feature is turned
o before entering a car wash.
MEMORY FEATURE
*
The memory function will save and recall
the positions of the driver seat, power
mirrors and adjustable pedals. Use the
memory controls located on the le side
of the driver’s seat
to program
and then recall memory positions.
To program
1. Switch on the ignition.
2. Move the memory features to your
desired position.
3. Press and hold the 1 button
until
you hear a tone.
Use this same procedure to set the
second position using the 2 button
.
You can now use these controls to recall
the set memory positions.
SOS POST-CRASH ALERT SYSTEM™
The SOS Post-Crash Alert System
provides audible and visual alarms in the
event of a crash. The direction indicators
will flash and the horn will sound. To
switch o the system, press the hazard
flasher control, or press
on your
remote transmitter.
COMFORT
SEATING-TO-CARGO VERSATILITY
Note: Before folding the second- or third-
row seats, make sure to flip down the head
restraints by pulling on the strap, and remove all
items from the floor and seats.
TO FOLD THE FLAT-FOLDING THIRD-ROW
SEATS TO THE LOAD FLOOR
Pull up on the Handle located behind the
seatback while pushing the seatback forward
and down into the seat cushion.
Note: You may need to exert a moderate force
to move the seat forward and down.
To return the seats to an upright
seating position
Li and pull the seat rearward until the
latch engages fully.
Pull Strap
Handle
E-Z ENTRY INTO THE
THIRD-ROW SEATS
The E-Z entry seat allows for easier
entry and exit to and from the
third-row seat.
To enter the third-row seating area
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat
and release the handle.
4. Pull the handle up again until the
seat releases from the floor.
5. Push the seat upward and fold it
away from the third row.
To return the seat to an upright
seating position
1. Push the seat down and latch it
to the floor.
2. Bring the seatback to an upright
position. It should lock into position.
3. Li up on the head restraint until it
locks into its original position.
Lever 1
Position 2
Position 3
page 11
page 10
*if equipped
To Next Page
Loading...
