Vehicles Without Intelligent Access
1. Insert a screwdriver into the recess on
the back of the key and remove the key
blade.
2. Release the retaining clips with the
screwdriver and separate the two
halves of the remote control.
Note: Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
3. Carefully pry out the battery with the
screwdriver.
4. Install a new battery (3V CR 2032) with
the + facing upward.
5. Assemble the two halves of the remote
control.
6. Install the key blade.
Integrated Keyhead Transmitter
1. Twist a thin coin in the slot of the
transmitter near the key ring to remove
the battery cover.
2. Remove the old battery.
45
Fiesta (CCT) Vehicles Built From: 01-04-2013, Vehicles Built Up To: 31-12-2013
Keys and Remote Controls
To Next Page
Loading...
