USING STABILITY CONTROL
AdvanceTrac™ with Roll Stability
Control™ (RSC™)
The system automatically activates when
you start your engine. You can switch off
the electronic stability control and roll
stability control portions of the system
below 35 mph (56 km/h). When the
transmission is in reverse (R), they are
disabled. You can switch off the traction
control portion of the system
independently. See Using Traction
Control (page 197).
AdvanceTrac with RSC Features
Traction
control system
Electronic
stability
control
Roll stability
control
Stability
control OFF
light
Button func-
tions
EnabledEnabledEnabledIlluminated
during bulb
check
Default at start-
up
DisabledEnabledEnabledIlluminatedButton pressed
momentarily
DisabledDisabledEnabledIlluminatedButton pressed
and held for
more than 5
seconds at
vehicle speed
under 35 mph
(56 km/h)
Enable with
higher threshold
target
Enabled with
higher threshold
target
EnabledIlluminatedVehicle speed
exceeds 35 mph
(56 km/h) after
button is
pressed and
held for more
than 5 seconds
Enabled with
higher threshold
target
Enabled with
higher threshold
target
EnabledIlluminatedDouble press
EnabledEnabledEnabledNot illuminatedButton pressed
again after
deactivation
DisabledDisabledDisabledIlluminatedTransfer case
switched to
4WD Low
Locked
199
F-150 (), enUSA, First Printing
Stability Control
To Next Page
Loading...
